Federal Register - August 10, 2021
Version en texte Qu'est-ce que c'est?Dateas est un site Web indépendant, non affilié à un organisme gouvernemental. La source des documents PDF que nous publions est l'agence officielle indiquée dans chacun d'eux. Les versions en texte sont des transcriptions non officielles que nous faisons pour fournir de meilleurs outils d'accès et de recherche d'informations, mais peuvent contenir des erreurs ou peuvent ne pas être complètes.
Source: Federal Register
43643
Federal Register / Vol. 86, No. 151 / Tuesday, August 10, 2021 / Notices Signed in Washington, DC, on August 5, 2021.
Treena V. Garrett, Federal Register Liaison Officer, U.S.
Department of Energy.
the legal effect of this document upon publication in the Federal Register.
The design characteristics constituting the grounds for the Interim Waiver Application:
Appendix C to Subpart R of Part 431Uniform Test Method for the
OF
Request for Interim Waiver from a DOE test procedure pursuant to
CO2 Direct Expansion Unit Coolers in Medium and Low Temperature
Measurement of Net Capacity and AWEF of Walk-in Cooler and Walk-in Freezer Refrigeration Systems specifies that unit coolers tested alone use the test procedures described in AHRI
12502009. Table 15 and Table 16 of AHRI 12502009 are as follows:
Unit cooler air entering Liquid relative Saturated inlet Liquid inlet humidity, suction saturation subcooling Compressor %
temp, F temp, F
temp, F
capacity
Off Cycle Fan Power
35
<50
-
-
Refrigeration Capacity Suction A
35
<50
25
105
9 Compressor Determine Net On Refrigeration Capacity of Unit Cooler.
Refrigeration Capacity Suction B
35
<50
20
105
9 Compressor Determine Net On Refrigeration Capacity of Unit Cooler.
Compressor Measure fan Off input power during compressor of1
cycle.
EN10AU21.016
-
Test objective
VerDate Sep<11>2014
17:05 Aug 09, 2021
Jkt 253001
PO 00000
Frm 00020
Fmt 4703
Sfmt 4725
E:FRFM10AUN1.SGM
10AUN1
EN10AU21.015
jbell on DSKJLSW7X2PROD with NOTICES
Test description
Unit cooler air entering dry-bulb,
Application for Interim Waiver
provisions described in 10 CFR 431.401
for the following product on the grounds that the basic model contains one or more design characteristics that prevent testing of the basic model according to the prescribed test procedures.
