Federal Register - February 23, 2021
Version en texte Qu'est-ce que c'est?Dateas est un site Web indépendant, non affilié à un organisme gouvernemental. La source des documents PDF que nous publions est l'agence officielle indiquée dans chacun d'eux. Les versions en texte sont des transcriptions non officielles que nous faisons pour fournir de meilleurs outils d'accès et de recherche d'informations, mais peuvent contenir des erreurs ou peuvent ne pas être complètes.
Source: Federal Register
Federal Register / Vol. 86, No. 34 / Tuesday, February 23, 2021 / Rules and Regulations
BILLING CODE 491013C
i Replacement of Repaired NLG and/or MLG Component If the total flight cycles of the component is equal to or more than the applicable revised SDIR life limit specified in figure 1
to paragraph h of this AD minus 2,000 flight cycles: Within 12 months or 2,000 flight cycles, whichever occurs first, after completing the actions specified in paragraph g of this AD, replace the affected component with a serviceable component.
j Parts Installation Prohibition As of the effective date of this AD, no person may install any component listed in Table 1 or Table 2 of Bombardier Service Bulletin 601R32112, dated November 11,
VerDate Sep<11>2014
21:28 Feb 22, 2021
Jkt 253001
2019, on any airplane without first incorporating the actions specified in paragraph h or i of this AD, as applicable.
k Other FAA AD Provisions The following provisions also apply to this AD:
1 Alternative Methods of Compliance AMOCs: The Manager, New York ACO
Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards Office, as appropriate. If sending information directly to the manager of the certification office, send it to ATTN:
Program Manager, Continuing Operational
PO 00000
Frm 00064
Fmt 4700
Sfmt 4700
Safety, FAA, New York ACO Branch, 1600
Stewart Avenue, Suite 410, Westbury, NY
11590; telephone 5162287300; fax 516
7945531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local Flight Standards Office.
2 Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, New York ACO Branch, FAA; or Transport Canada Civil Aviation TCCA; or MHI RJ Aviation ULCs TCCA
Design Approval Organization DAO. If approved by the DAO, the approval must include the DAO-authorized signature.
E:FRFM23FER1.SGM
23FER1
ER23FE21.012
10766
