Je veux savoir à propos de…

12380

FEDERAL REGISTER, Wednesday, September 8, 1943

comply with the regulations of the De pose in such parts on April 13,1943, and be used in the manufacture of two wheel partment of Agriculture or other federal zinc may be used for galvanizing when hand trucks, platform trucks, dollies, or semi-live platforms, except where the agency, or with a state law, or where it required by regulations of the Depart normal load capacity is 2,500 pounds or would be required if such federal regula ment of Agriculture or other federal more, and except also that ball bearings tions were applicable in intrastate com agency, or by a state law, or where it of other than alloy steel may be used merce,or where necessary for the transwould be required if such federal regula in the swivel bearings or casters. This portation of hot forgings, castings, heat tions were applicable in intrastate com restriction shall not be deemed to pro treated or other hot metal parts, or loads hibit the use of pin bearings using un merce.
ground steel pins of other than alloy e Required certification with orders. in excess of 10,000 pounds.
steel.
2 The limitations and restrictions of Each person placing an order for de 3 Restrictions on use of cast steel subparagraphs 2 to 6 inclusive, of livery of 1 new platform trucks, trail wheels. No cast steel wheels shall be paragraph d of this order shall not ers or platforrfis with steel or iron platused in the manufacture of two wheel apply:
forms, or 2
new all steel or iron plat hand trucks, platform trucks, lift trucks, i To the manufacture, delivery and lift jacks, portable platform type ele forms, trailers or platfbrm trucks, or 3
acceptance of parts which are to be used vators, dollies, or semi-live platforms.
new steel supported platforms to carry for repair and maintenance only and 4 Other restrictions on use of iron which cannot be used for replacement on loads in excess of 6,000 pounds, shall and steel. No iron or steel shall be used existing equipment in a practical man certify to his supplier on the purchase in the manufacture of the equipment ner if made in conformity with such order or in an accompanying letter, as a specified below, elsewhere than in bear specifications and restrictions;
condition to receiving such delivery, in ings, wheels, axles, axle housings, caster ii To the manufacture, delivery and brackets, or small hardware.
formation in statements substantially as acceptance o f parts which on April 23, i In two wheel hand trucks, except follows, respectively;
1943, had been fabricated or processed to in halfstrap nose, legs, or lg braces;
the extent that any other use would be i The undersigned hereby certifies except in the cross bars, hoops; clamps, impractical;
that the steel or iron platform on the or hooks of barrel trucks; and except in iii To the manufacture, delivery and platform trucks, trailers, or plat protective strapping on two wheel hand acceptance of any hand trucks or other fo rm hereby ordered is are neces trucks to be used in stevedore operations handling equipment in the process of and having a load capacity of 1,000
sary in meat packing or processing as manufacture on April 23,1943, and to be pounds or more;
used in filling any order accepted by the required by regulations of the Depart ii In platform trucks, except in manufacturer prior to said date;
ment of Agriculture or other federal tongue type handles, stake pockets, and iv Until 90 days after April 13, 1943, agency, or by a state law, or where it turntable in fifth wheel types;
to the manufacture, delivery and accep iii In the flooring of trailers, except would be required if such federal regula tance of any hand trucks or other han in edging and binding;
dling equipment to be delivered to, and tions were applicable in intrastate com iv In dollies;
for direct use of, the Army, Navy, Mari merce.
v In platforms, except in legs; in time Commission or War Shipping Ad ii The undersigned hereby certifies semi-live platforms, except in legs and ministration, to the extent that any ap engaging pins; in angle iron supports on that the all steel or iron platformfs or plicable specifications of any such or sides and strap or angle iron protection platform trucks or trailers hereby ganization require construction, design on ends of platforms only where load ca or materials not in accordance with the ordered is are necessary to handle hot pacity is 6,000 pounds or more;
provisions of this order. As used in this metal parts, or that the load to be vi In pallets;
paragraph, the terms Army , Navy, handled will exceed 10,000 pounds.
vii In the platforms and back plates Maritime Commission and War Ship iii The undersigned hereby certifies of portable platform type elevators, ping Administration shall not include except in edging and binding; or that the steel supported platforms any privately operated plants or ship viii In racks.
hereby ordered is are necessary to yards financed by or controlled by any 5 Restrictions on use of copper and of those organizations, or operated on a carry loads in excess of 6,000 pounds.
copper base alloy. No copper or copper cost-plus-fixed-fee basis.
Such certification shall in every case be base alloy shall be used in the manufac 3 The limitations and restrictions of signed by the purchaser or an author ture of hand trucks, pallets, or platforms, subparagraph 4 of paragraph d of ized official, either manually or as pro except in hydraulic packing washers, or this order shall not apply to the manu vided in Priorities Regulation No. 7.
where the use of other materials would facture, delivery and acceptance of port No person shall make delivery under any create a definite explosion-hazard as a able dough troughs, portable bread such order if he knows, or has reason to result of the necessity of using such racks and proof racks, portable dump believe, that the certificate is false; and equipment in the same room with, or in racks for bread, and portable mixture no person shall falsely furnish any such other close proximity to materials subject bowl stands for dough or other ingredi certification. Such certification shall to explosive reaction. from sparks, such ents, when such equipment is designed constitute a representation to the War as black powder, lead azide, igniter com for use by, and to be delivered to or for Production Board, as well as to the sup position, tracer mixtures, primer mix the account of the United States Navy or plier, that the statements therein are tures, incendiary composition, vapors Army, or laundry truck tubs designed true. Any manufacturer or dealer may from combustible substances, or dust for use aboard ship and to be delivered to rely upon the information therein and from explosives.
or for the account of the United States shall not be responsible for any action 6 Restrictions on use of aluminum, Navy, or Army.
taken by him under this order in reliance tin, cadmium, zinc, stainless or alloy g Miscellaneous provisions 1 Ap upon inaccurate or untrue statements plicability of regulations, This order steel, and metallic plating and finishes.
and all transactions affected thereby are therein, unless he knows or has reason No aluminum, tin, cadmium, zinc, stain subject to all applicable provisions of the to believe that such statements are in less or alloy steel, metallic plating or regulations of the War Production Board, accurate or untrue.
metallic finishes shall be used in the as issued and amended from time to time.
f Exemptions and exceptions. 1
manufacture of hand trucks, pallets, or N ote : Paragraph g 1 amended Septem The limitations and restrictions con platforms, except that alloy steel may ber 6, 1943.
tained in subparagraphs 4 i i , iii be used in bearings where permitted 2 Revoked September 6, 19431.
and v of paragraph d shall not ap under paragraph d 2 above, or in 3 Revoked September 6, 19431.
ply to the use of iron or steel where lift trucks or lift jacks where necessary 4 Violations. Any person who wil necessary in equipment manufactured to afford strength, and being used by fully violates any provision of this order, or who, in connection with this order, for use in meat packing or processingto the manufacturer thereof for that pur