Voglio sapere a riguardo di…

Federal Register / Vol. 86, No. 167 / Wednesday, September 1, 2021 / Proposed Rules
49223

Figure 2.12.5-Determination of Extra-Hot Wash/Cold Rinse
Exira-Hot WashlCold !Rinse 11Extra-Hot/Cold"

D the dothll, wablr l:lave Im lntefnali water hlldtr?

Ill ill ill
No
-

Ooll lbl Wl1llffllr mfermI

Nik, nltctkms N
avalll.llil M

dalhn lllBllher, l:tltll meet at of ltll, crttetrla?
WUlI t11111 , , um
136"F

Coldne ii
,.

lntlndtd fo!"ll!Bffllrl;
No
1111

The IW!e11! le1t eyclie dol1 ild. lndllde 1

1111ft Ef:11:t-Hot WsahCold R/mlll,
3. Test Measurements
khammond on DSKJM1Z7X2PROD with PROPOSALS3

3.2.5 Wash time setting.
3.2.5.1 If the cycle under test offers a range of wash time settings, the wash time setting shall be the higher of either the minimum or 70 percent of the maximum wash time available for the wash cycle under test, regardless of the labeling of suggested dial locations. If 70 percent of the maximum wash time is not available on a dial with a discrete number of wash time settings, choose the next-highest setting greater than 70 percent.
3.2.5.2 If the clothes washer is equipped with an electromechanical dial or timer controlling wash time that rotates in both directions, reset the dial to the minimum wash time and then turn it in the direction of increasing wash time to reach the appropriate setting. If the appropriate setting
VerDate Sep<11>2014

17:31 Aug 31, 2021

Jkt 253001

is passed, return the dial to the minimum wash time and then turn in the direction of increasing wash time until the appropriate setting is reached.

setting that uses the least water. Average the results of the third and fourth tests to obtain the energy and water consumption values for the average test load size.

3.2.6

3.2.6.2.2 User-adjustable. Conduct four tests on clothes washers with user-adjustable automatic water fill controls. Conduct the first test using the maximum test load and with the automatic water fill control system set in the setting that uses the most water.
Conduct the second test using the minimum test load and with the automatic water fill control system set in the setting that uses the least water. Conduct the third test using the average test load and with the automatic water fill control system set in the setting that uses the most water. Conduct the fourth test using the average test load and with the automatic water fill control system set in the
PO 00000

Frm 00085

Fmt 4701

Sfmt 4702

3.2.7 Manufacturer default settings. For clothes washers with electronic control systems, use the manufacturer default settings for any cycle selections, except for 1 the temperature selection, 2 the wash water fill levels, 3 if necessary, the spin speeds on wash cycles used to determine remaining moisture content, or 4 network settings. If the clothes washer has network capabilities, the network settings must be disabled throughout testing if such settings can be disabled by the end-user and the products user manual provides instructions on how to do so. For all other cycle selections, the manufacturer default settings must be used for wash conditions such as agitation/tumble operation, soil level, spin
E:FRFM01SEP3.SGM

01SEP3

EP01SE21.017

BILLING CODE 645001C