Voglio sapere a riguardo di…

31906

Federal Register / Vol. 86, No. 114 / Wednesday, June 16, 2021 / Rules and Regulations
use this process. As a result, EASA AD
20180082 is incorporated by reference in this final rule. This AD, therefore, requires compliance with EASA AD
20180082 in its entirety, through that incorporation, except for any differences identified as exceptions in the regulatory text of this AD. Using common terms that are the same as the heading of a particular section in the EASA AD does not mean that operators need comply only with that section. For example, where the AD requirement refers to all required actions and compliance times, compliance with this AD requirement is not limited to the section titled Required Actions and Compliance Times in the EASA
AD. Service information specified in EASA AD 20180082 that is required for compliance with EASA AD 20180082
is available on the internet at https
www.regulations.gov by searching for and locating Docket No. FAA2021
0446.
Differences Between This AD and the MCAI
The requirements specified in paragraphs 1, 2, 3 and 5 of EASA
AD 20180082 do not apply to this AD.
FAAs Justification and Determination of the Effective Date Section 553b3B of the Administrative Procedure Act 5 U.S.C.
authorizes agencies to dispense with notice and comment procedures for rules when the agency, for good cause finds that those procedures are impracticable, unnecessary, or contrary to the public interest. Under this section, an agency, upon finding good cause, may issue a final rule without
seeking comment prior to the rulemaking.
There are currently no domestic operators of these products. Therefore, the FAA finds that notice and opportunity for prior public comment are unnecessary and that good cause exists pursuant to 5 U.S.C. 553d for making this amendment effective in less than 30 days.
Comments Invited The FAA invites you to send any written relevant data, views, or arguments about this AD. Send your comments to an address listed under ADDRESSES. Include Docket No. FAA
20210446; Project Identifier 2018SW
029AD at the beginning of your comments. The most helpful comments reference a specific portion of the AD, explain the reason for any recommended change, and include supporting data. The FAA will consider all comments received by the closing date and may amend this AD because of those comments.
Except for Confidential Business Information CBI as described in the following paragraph, and other information as described in 14 CFR
11.35, the FAA will post all comments received, without change, to https
www.regulations.gov, including any personal information you provide. The agency will also post a report summarizing each substantive verbal contact received about this AD.
Confidential Business Information CBI is commercial or financial information that is both customarily and actually treated as private by its owner.
Under the Freedom of Information Act
FOIA 5 U.S.C. 552, CBI is exempt from public disclosure. If your comments responsive to this AD contain commercial or financial information that is customarily treated as private, that you actually treat as private, and that is relevant or responsive to this AD, it is important that you clearly designate the submitted comments as CBI. Please mark each page of your submission containing CBI as PROPIN. The FAA
will treat such marked submissions as confidential under the FOIA, and they will not be placed in the public docket of this AD. Submissions containing CBI
should be sent to Andrea Jimenez, Aerospace Engineer, Airframe and Propulsion Section, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone:
5162287330; fax: 5167945531;
email: 9-avs-nyaco-cos@faa.gov. Any commentary that the FAA receives that is not specifically designated as CBI will be placed in the public docket for this rulemaking.
Regulatory Flexibility Act RFA
The requirements of the RFA do not apply when an agency finds good cause pursuant to 5 U.S.C. 553 to adopt a rule without prior notice and comment.
Because the FAA has determined that it has good cause to adopt this rule without notice and comment, RFA
analysis is not required.
Costs of Compliance Currently, there are no affected U.S.registered helicopters. If an affected helicopter is imported and placed on the U.S. Register in the future, the FAA
provides the following cost estimates to comply with this AD:

ESTIMATED COSTS FOR REQUIRED ACTIONS
Labor cost
Parts cost
Cost per product
32 work-hours $85 per hour = $2,720

$2,000

$4,720

jbell on DSKJLSW7X2PROD with RULES

According to the manufacturer, some or all of the costs of this AD may be covered under warranty, thereby reducing the cost impact on affected individuals. The FAA does not control warranty coverage for affected individuals. As a result, the FAA has included all known costs in the cost estimate.
Authority for This Rulemaking Title 49 of the United States Code specifies the FAAs authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII:

VerDate Sep<11>2014

15:52 Jun 15, 2021

Jkt 253001

Aviation Programs, describes in more detail the scope of the Agencys authority.
The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA
with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce.
This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or
PO 00000

Frm 00002

Fmt 4700

Sfmt 4700

develop on products identified in this rulemaking action.
Regulatory Findings The FAA determined that this AD
would not have federalism implications under Executive Order 13132. This AD
would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I
certify this regulation:

E:FRFM16JNR1.SGM

16JNR1