Quiero saber acerca de...

48920

Federal Register / Vol. 86, No. 167 / Wednesday, September 1, 2021 / Proposed Rules country, and is approved for operation in the United States. Pursuant to the FAAs bilateral agreement with the State of Design Authority, the FAA has been notified of the unsafe condition described in the MCAI and service information referenced above. The FAA
is proposing this AD because the FAA
evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design.

the MCAI for additional background information.
Related Service Information Under 1
CFR Part 51
EASA AD 20180255 describes procedures for modifying the waste compartment door of each affected galley. The modification includes installing a door catch bracket and a new striker.
Safran has issued Zodiac Galleys Europe Service Bulletin 21351025
001, Revision B, dated January 28, 2018;
Zodiac Galleys Europe Service Bulletin 21351025001, Revision C, dated May 24, 2018; and Safran Service Bulletin 21351025001, Revision D, dated August 15, 2019. This service information describes procedures for modifying the waste compartment door of each affected galley by installing a door catch bracket and striker. These documents are distinct because they contain revised instructions and figures.
This material is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

Proposed AD Requirements This proposed AD would require accomplishing the actions specified in EASA AD 20180255 described previously, as incorporated by reference, except for any differences identified as exceptions in the regulatory text of this AD.
Explanation of Required Compliance Information
FAAs Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another
In the FAAs ongoing efforts to improve the efficiency of the AD
process, the FAA developed a process to use some civil aviation authority CAA
ADs as the primary source of information for compliance with requirements for corresponding FAA
ADs. The FAA has been coordinating this process with manufacturers and
CAAs. As a result, the FAA proposes to incorporate EASA AD 20180255 by reference in the FAA final rule. This proposed AD would, therefore, require compliance with EASA AD 20180255
in its entirety through that incorporation, except for any differences identified as exceptions in the regulatory text of this proposed AD.
Using common terms that are the same as the heading of a particular section in EASA AD 20180255 does not mean that operators need comply only with that section. For example, where the AD
requirement refers to all required actions and compliance times, compliance with this AD requirement is not limited to the section titled Required Actions and Compliance Times in EASA AD 20180255.
Service information required by EASA
AD 20180255 for compliance will be available at https www.regulations.gov by searching for and locating Docket No.
FAA20210722 after the FAA final rule is published.
Costs of Compliance The FAA estimates that this proposed AD affects 141 airplanes of U.S. registry.
The FAA estimates the following costs to comply with this proposed AD:

khammond on DSKJM1Z7X2PROD with PROPOSALS

ESTIMATED COSTS FOR REQUIRED ACTIONS
Labor cost
Parts cost
Cost per product
Cost on U.S.
operators
5 work-hours $85 per hour = $425

$0

$425

$59,925

According to the manufacturer, some or all of the costs of this proposed AD
may be covered under warranty, thereby reducing the cost impact on affected operators. The FAA does not control warranty coverage for affected operators.
As a result, the FAA has included all known costs in the cost estimate.

regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce.
This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Authority for This Rulemaking
Regulatory Findings The FAA determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I
certify this proposed regulation:
1 Is not a significant regulatory action under Executive Order 12866, 2 Would not affect intrastate aviation in Alaska, and
Title 49 of the United States Code specifies the FAAs authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII:
Aviation Programs, describes in more detail the scope of the Agencys authority.
The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA
with promoting safe flight of civil aircraft in air commerce by prescribing
VerDate Sep<11>2014

16:23 Aug 31, 2021

Jkt 253001

PO 00000

Frm 00003

Fmt 4702

Sfmt 4702

3 Would not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39AIRWORTHINESS
DIRECTIVES
1. The authority citation for part 39
continues to read as follows:

Authority: 49 U.S.C. 106g, 40113, 44701.

E:FRFM01SEP1.SGM

01SEP1