Quiero saber acerca de...

10774

Federal Register / Vol. 86, No. 34 / Tuesday, February 23, 2021 / Rules and Regulations
The FAA has received no definitive data on which to base the cost estimates for the on-condition actions specified in this AD.
According to the manufacturer, some or all of the costs of this AD may be covered under warranty, thereby reducing the cost impact on affected operators. The FAA does not control warranty coverage for affected operators.
As a result, the FAA has included all known costs in the cost estimate.
Authority for This Rulemaking Title 49 of the United States Code specifies the FAAs authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII:
Aviation Programs, describes in more detail the scope of the Agencys authority.
The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA
with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce.
This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I
certify that this AD:
1 Is not a significant regulatory action under Executive Order 12866, 2 Will not affect intrastate aviation in Alaska, and 3 Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator,
VerDate Sep<11>2014

21:28 Feb 22, 2021

Jkt 253001

the FAA amends 14 CFR part 39 as follows:
PART 39AIRWORTHINESS
DIRECTIVES
1. The authority citation for part 39
continues to read as follows:

Authority: 49 U.S.C. 106g, 40113, 44701.
39.13

Amended
2. The FAA amends 39.13 by adding the following new airworthiness directive:

20210210 Airbus SAS: Amendment 39
21393; Docket No. FAA20200969;
Project Identifier MCAI202000853T.
a Effective Date This airworthiness directive AD is effective March 30, 2021.
b Affected ADs None.
c Applicability This AD applies to all Airbus SAS Model A350941 and 1041 airplanes, certificated in any category.
d Subject Air Transport Association ATA of America Code 52, Doors.
e Reason This AD was prompted by a report that certain retaining rings could cause damage to frame forks, brackets and edge frames, and their surface protection; subsequent investigation showed that the depth of the frame fork spotfacing on structural parts is inadequate to accommodate the retaining ring. The FAA is issuing this AD to address inadequate frame fork spotfacing depth for the retaining rings, which could reduce the structural integrity of the airplane.
f Compliance Comply with this AD within the compliance times specified, unless already done.
g Requirements Except as specified in paragraph h of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency EASA AD 20200144, dated June 29, 2020 EASA AD 20200144.
h Exceptions to EASA AD 20200144
1 Where EASA AD 20200144 refers to its effective date, this AD requires using the effective date of this AD.
2 The Remarks section of EASA AD
20200144 does not apply to this AD.
i Other FAA AD Provisions The following provisions also apply to this AD:
1 Alternative Methods of Compliance AMOCs: The Manager, Large Aircraft Section, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures
PO 00000

Frm 00072

Fmt 4700

Sfmt 4700

found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the Large Aircraft Section, International Validation Branch, send it to the attention of the person identified in paragraph j of this AD.
Information may be emailed to: 9-AVS-AIR730-AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.
2 Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, Large Aircraft Section, International Validation Branch, FAA; or EASA; or Airbus SASs EASA Design Organization Approval DOA. If approved by the DOA, the approval must include the DOA-authorized signature.
3 Required for Compliance RC: Except as required by paragraph i2 of this AD, if any service information contains procedures or tests that are identified as RC, those procedures and tests must be done to comply with this AD; any procedures or tests that are not identified as RC are recommended. Those procedures and tests that are not identified as RC may be deviated from using accepted methods in accordance with the operators maintenance or inspection program without obtaining approval of an AMOC, provided the procedures and tests identified as RC can be done and the airplane can be put back in an airworthy condition. Any substitutions or changes to procedures or tests identified as RC require approval of an AMOC.
j Related Information For more information about this AD, contact Kathleen Arrigotti, Aerospace Engineer, Large Aircraft Section, International Validation Branch, FAA, 2200
South 216th St., Des Moines, WA 98198;
telephone and fax 2062313218; email kathleen.arrigotti@faa.gov.
k Material Incorporated by Reference 1 The Director of the Federal Register approved the incorporation by reference IBR of the service information listed in this paragraph under 5 U.S.C. 552a and 1 CFR
part 51.
2 You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.
i European Union Aviation Safety Agency EASA AD 20200144, dated June 29, 2020.
ii Reserved 3 For EASA AD 20200144, contact the EASA, Konrad-Adenauer-Ufer 3, 50668
Cologne, Germany; telephone +49 221 8999
000; email ADs@easa.europa.eu; Internet www.easa.europa.eu. You may find this EASA AD on the EASA website at https
ad.easa.europa.eu.
4 You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 2062313195. This material may be found
E:FRFM23FER1.SGM

23FER1